Инструкция С Настройками для Sunpentown WA1350DE
11
Fig.12
Fig.13
Exhaust hose installation:
Install or remove the exhaust according to usage
mode:
Install or remove the exhaust according to usage
mode:
COOL or AUTO mode
Install
FAN or DRY mode
Remove
1. Install the exhaust hose to unit as depicted in
Fig.12.
2. Install the exhaust adaptor to the hose as shown
in Fig.13. Refer to previous pages for window kit
installation.
installation.
IMPORTANT
KEEP CURVE OF EXHAUST HOSE SMOOTH,
WITHOUT ANY KINKS OR SHARP BENDS.
Fig.14
VENT CONTROL feature
The Vent Control is located on the back of the unit:
The Vent Control is located on the back of the unit:
OPEN position: removes stale air from the room
and exhausts it to the outside. Fresh air is drawn
in through normal passages in the home
and exhausts it to the outside. Fresh air is drawn
in through normal passages in the home
CLOSE position: no air circulation.
Fig.15
Continuous Water Drainage:
Remove drain plug from back of unit. Attach drain
hose to the opening. Direct other end of hose
directly over drain area. (Fig.15)
hose to the opening. Direct other end of hose
directly over drain area. (Fig.15)
This is recommended when running the unit in
DRY mode.
DRY mode.
Not recommended to use with COOL mode; the
cooling efficiency will actually be reduced.
cooling efficiency will actually be reduced.
Note: Make sure the connection between the hose
and unit is tight and without leak.
Emptying the bottom water tray
When the water level of the built-in bottom tray reaches a predetermined level, the panel
displays “P1”. At this time the Cooling or Dehumidifying process will immediately stop.
However, the fan motor will continue to operate. Carefully move the unit to a drain location (or
have a container placed under the spout), remove the bottom drain plug and let water flow out.
Restart the machine and “P1” symbol should disappear. If the error persists, call for service.
When the water level of the built-in bottom tray reaches a predetermined level, the panel
displays “P1”. At this time the Cooling or Dehumidifying process will immediately stop.
However, the fan motor will continue to operate. Carefully move the unit to a drain location (or
have a container placed under the spout), remove the bottom drain plug and let water flow out.
Restart the machine and “P1” symbol should disappear. If the error persists, call for service.
Note: be sure to replace the bottom drain plug before restarting the unit.