Инструкции По Установке для Maytag W10315283RP
2
2.
Move the door strike
Using a Torx
®†
T25 screwdriver, remove the 2 screws securing
the door strike to the door frame of the dryer. Remove the 4
screws above and below the door strike and set aside for later
use. Rotate the strike 180° and attach to the opposite side of
dryer door frame, as shown.
† ® TORX is a registered trademark of Saturn Fasteners, Inc.
3.
Remove inner door from
outer door
Position the door with the inside of the door facing up.
Using a Phillips screwdriver, remove the 17 screws securing
the inner door to the outer door. Lift off the inner door and
set aside.
NOTE: There is a small release tab on each side of the door.
If the inner and outer door do not separate easily, slide a
credit card, putty knife, or similar flat object between the inner
and outer doors at the locations shown to release the tab.
4.
Remove outer door trim
Using a Phillips screwdriver, remove the 4 screws attaching
the outer door trim to the outer door liner/window assembly
and remove trim.
5.
Remove door handle screws
Using a Phillips screwdriver, remove the 2 screws attaching
the outer window and door handle to the outer door liner and
remove.
Release tab
Release tab