Инструкции Пользователя для Electrolux E32AF75JPS

1.   Remove handles from carton and any other   
 protective 

packaging.

2.   Position fresh food handle end caps over upper  
 

and lower preinstalled shoulder bolts (A) that are  

 

fastened into door.

3.   While holding handle fi rmly against door, fasten  
 

upper and lower Allen set screws (B) with supplied  

 

Allen wrench until there is no gap between handle  

 and 

door.

 

To remove the toe grille, use a Phillips head 
screwdriver and remove the two screws holding the 
toe grille to the cabinet.  Then pull the toe grille away 
from the unit.

•   The freezer must have all bottom corners resting 

fi rmly on a solid fl oor.

• 

The fl oor must be strong enough to support a fully

 loaded 

freezer.

•   It is VERY IMPORTANT for your freezer to be 

level in order to function properly.  If the freezer 
is not leveled during installation, the door may be 
misaligned and not close or seal properly, causing 
cooling, frost or moisture problems.

Leveling instructions continued on next page.

All set screws should be tightened so the screw is 
below the surface of the handle. The handles should 
be drawn tight to freezer and refrigerator doors with 
no gaps. Opening the opposite door while tightening 
the Allen screw makes installation easier.

The door handle may loosen over time or if it was 
installed improperly. If this happens, tighten the set 
screws on the handles.