Справочник Пользователя для IBM LPCI-COM232-4

  
The card uses one address space. COM A, COM B, COM C, COM D, COM E, COM F, COM G and COM 
H each occupy eight consecutive register locations. The interrupt register which indicates which port or 
ports caused the interrupt is located at base address + 64.  
  
PCI architecture is Plug-and-Play. This means that the BIOS or Operating System determines the 
resources assigned to PCI cards rather than you selecting those resources with switches or jumpers. As a 
result, you cannot set or change the card's base address. You can only determine what the system has 
assigned. 
  
To determine the base address that has been assigned, run the PCIFind.EXE utility program provided. 
This utility will display a list of all of the cards detected on the PCI bus, the addresses assigned to each 
function on each of the cards, and the respective IRQs (if any) allotted. 
  
Alternatively, some operating systems (Windows 95/98/2000/XP) can be queried to determine which 
resources were assigned. In these operating systems, you can use the Device Manager utility from the 
System Applet of the control panel. The card is installed in the Data Acquisition class of the Device 
Manager list. Selecting the card, clicking Properties, and then selecting the Resources Tab will display a 
list of the resources allocated to the card. 
  
The PCI bus supports 64K of I/O space. Your card's addresses may be located anywhere in the 0000 to 
FFFF hex range. 
  
PCIFind uses the Vendor ID and Device ID to search for your card, then reads the base address and 
IRQ. 
  
If you want to determine the base address and IRQ yourself, use the following information. 
  
The Vendor ID for the card is 494F. (ASCII for "IO") 
The Device ID for the card is 10E8h. 

Manual LPCI-COM-8SM 

16