Справочник Пользователя для Mitsubishi Electronics C64T

 

6 

8101  MACRO SINGLE 

Select the control of the blocks where the user 
macro command continues. 

0:  Do not stop while macro block continues. 
1:  Stop every block during signal block operation. 

0/1 

8102  COLL. ALM OFF 

Select the interference (bite) control to the 
workpiece from the tool diameter during cutter 
compensation and nose R offset. 

0:  An alarm is output and operation stops when 

an interference is judged. 

1:  Changes the path to avoid interference. 

0/1 

8103  COLL. CHK OFF 

Select the interference (bite) control to the work 
from the tool diameter during cutter compensation 
and nose R offset. 

0:  Performs interference check 
1:  Does not perform interference check 

0/1 

8105  EDIT LOCK B 

Select the edit lock for program Nos. 8000 to 9999. 

0:  Program can be edited. 
1:  Editing of above program is prohibited. 

0/1 

8106  G46 NO REV-ERR 

(For L system only) 

Select the control for the compensation direction 
reversal in G46 (nose R offset). 

0:  An alarm is output and operation stops when 

the compensation direction is reversed (G41 
→ G42‚ G42 → G41). 

1:  An alarm does not occur when the compensa- 

tion direction is reversed‚ and the current 
compensation direction is maintained. 

0/1 

8107  R COMPENSATION 

0:  In arc cutting mode, the machine moves to the 

inside because of a delay in servo response to 
a command, making the arc smaller than the 
command value. 

1:  In arc cutting mode, the machine compensates 

the movement to the inside because of a delay 
in servo response to a command 

0/1 

8108  R COMP Select 

Specify whether to perform arc radius error 
correction over all axes or axis by axis. 

0:  Perform correction over all axes. 
1:  Perform correction over axis by axis. 

(Note)  This parameter is effective only when 

"#8107 R COMPENSATION" is 1. 

0/1 

8109  HOST LINK 

Not used. 

0