Справочник Пользователя для Mitsubishi Electronics C64T

 

17 

 

1025 l_plane  Initial plane 

selection 

Specify the plane to be selected when the power is 
turned on or reset. 
When 0 is specified, 1 is assumed (X-Y plane). 

1

:  X-Y plane (G17 

command state) 

2:  Z-X plane (G18 

command state) 

3:  Y-Z plane (G19 

command state)

 

1026 
1027 
1028 

base_l 
base_J 
base_K 

Base axis I 
Base axis J 
Base axis K 

Specify the basic axis address that composes the 
plane. 
Specify the axis address set in “#1013 axname”. 
Set the axis name even when there is no need to 
configure a plane, such as the case of 2-axis 
specifications. 
Normally‚ when X‚ Y and Z are specified respectively 
for base_l‚_J‚_K‚ the following relation will be 
established: 

G17: X-Y 
G18: Z-X 
G19: Y-Z 

Specify the desired address to set an axis address 
other than the above. 

Control axis 
addresses such as 
X, Y, and Z 

1029  aux_I 

Flat axis I 

If there is an axis parallel to "#1026 base_l"‚ specify 
that axis address. 

Control axis 
addresses such as 
X, Y, and Z 

1030  aux_J 

Flat axis J 

If there is an axis parallel to "#1027 base_J"‚ specify 
that axis address. 

Control axis 
addresses such as 
X, Y, and Z 

1031  aux_K 

Flat axis K 

If there is an axis parallel to "#1028 base_K"‚ specify 
that axis address. 

Control axis 
addresses such as 
X, Y, and Z