Справочник Пользователя для Meco Bonza Series

It is not necessary to remove and wash the Flavor Activators

in order to keep them clean. Burning off the residue after

each cooking should be sufficient. Heavy grease deposits

can be cleaned with a baking soda and water solution.

· Always turn the LP gas cylinder valve “Off” when

not in use. Allow grill to cool before handling parts

or cleaning.

· Empty the foil pan and grease tray after each

cooking session so excessive grease does not

accumulate. Failure to remove grease may result

in grease dripping onto the cart and/or a grease fire

in the tray.

· Never light the LP gas grill without the foil pan

and grease tray in place.

· Before each use, check your Bottom Panel, Grease Tray,

and Foil Pan. If there is excessive grease buildup, clean

and replace. Remove any charcoal and wood chunk ash

before each use.

· Make sure Bottom Panel, Grease Tray, & Foil Pan are in

place before each grilling session.

· Failure to remove grease from the Foil Pan may result in

grease dripping onto cart and/or a grease fire in tray.

The Foil Pan can be cleaned or replaced with a standard

size foil pan (apprx. 5-1/2” W. x 8-1/2” L. x 1-1/8” H.)

· Always turn off the LP gas cylinder at the LP

cylinder valve when not in use. Allow grill to cool

before handling parts or cleaning.

How to Clean the Grill Body

1) Remove cooking surfaces and burners before full

cleaning.

2) Remove excess grease and/or fat from the grill body

with a soft plastic or wooden scraper. Never use steel

wool or other abrasive cleaning product on porcelain

coated surfaces.

3) For further cleaning, use hot soapy water and a cloth, or

nylon-bristled brush only.

Do not immerse the gas

controls or manifold in water.

4) When finished cleaning, replace burners and cooking

surfaces according to Steps 8 and 10 in the

Assembly Instructions.

5) Check burner operation after reassembly. Check louver

operation after reassembly

Flavor Activators™

Bottom Panel/ Grease Tray

Cleaning the Grill Body

Cleaning instructions for Charcoal and

Wood chunk ash

(Do not clean grill while hot).

1. Remove Cooking Grids

2. Actuate louver adjusting knob in and out repeatedly

and brush the charcoal ashes off the louvers into the

bottom of the grill.

Louver

Adjusting

Knob

3. Remove the burners by removing the cotter pin and lift-

ing the burners out of the grill.

4. Raise the louvers as shown and dust the ashes from

the crossovers using a small brush.

Crossovers

5. With the louvers raised, brush the ashes from the

gas collector/igniter. You will need to raise each

pair of louvers and clean the ash from the grill.

Note: The ashes can be brushed into the bottom of

the grill for removal.

Gas Collector/Igniter