Справочник Пользователя для Mitsubishi Electronics MDS-B

III 

 

 

 

 
Install the servo amplifier, linear servomotor and regenerative resistor on noncombustible 
material. Direct installation on combustible material or near combustible materials could lead to 
fires. 

 
If a servo amplifier fault should occur, turn OFF the power on the servo amplifier's power 
supply side. If a large current continues to pass, fires could occur. 

 
Shut off the power with the error signal. Failure to do so could cause the regenerative resistor 
to abnormally overheat and fires to occur due to faults in the regenerative transistor, etc. 

 

 

CAUTION 

 

 
Do not apply a voltage other than that specified in Instruction Manual on each terminal. Failure 
to observe this item could lead to ruptures or damage, etc. 

 
Do not mistake the terminal connections. Failure to observe this item could lead to ruptures or 
damage, etc. 

 
Do not mistake the polarity(+, -) . Failure to observe this item could lead to ruptures or damage, 
etc. 

 
Do not touch the servo amplifier fins, regenerative resistor or linear motor, etc., while the power 
is turned ON or immediately after turning the power OFF. Some parts are heated to high 
temperatures, and touching these could lead to burns.