Справочник Пользователя для Carrier 1300L

14

Remove lamp by rotating lamp 90 degrees to align 

lamp pins with holder slots. Refer to Bi-Pin Fluores-

cent lamp Installation/Verification section on page 6.

The evaporator drain pan is located in the base of the 

cartridge. In general, the condensate disposal system 

is maintenance free.

The condenser should be inspected periodically for 

accumulation of debris, which should be removed. A 

vacuum cleaner or brush can be used to remove debris.

Cabinets should be cleaned with a solution of mild 

soap and water or mild household cleaner. Do not use 

caustic soap or abrasive cleaners, since these might 

damage the cabinet finish. If stainless steel surface 

becomes discolored, scrub by rubbing only in direction 

of the finish grain. Do not use steel wool or rusting 

may occur. Refer to Table 4.

The inside of the cabinet is coated with baked-on 

epoxy. To clean, use a mild soap and water solution or 

mild household cleaner.

Before proceeding with replacement, disconnect 

electrical service. Failure to unplug unit could result 

in serious personal injury or death.