Справочник Пользователя для Mitsubishi Electronics JT-SB216JSH-W-E

− 9 −

6

1.Run the power cable through the rubber 

bushing, and attach the rubber bushing to 

the terminal cover.

2.Attach the terminal cover to the main unit 

using the terminal cover mounting screw. 

3.Move the power cable to the left side of the 

terminal cover. 

4.Check that the power cable and wires are 

not pinched anywhere. 

5.Open the ferrite core.

6. Pass the power cable through the ferrite 

core, and close it. 

 Place the ferrite core on the outside of the terminal 

cover.

7. Check that the ferrite core is securely 

installed.

7

Fix the main unit in place. 
1.Engage the panel hooks of the installation 

panel (2 hooks) on the back of the 

appliance. 

If the wall is concrete, use commercially available 

metal screw plugs.

See "Plug Positioning" for details of where to insert 

the plugs.

Use a screwdriver that is longer than 150mm.

2.Check that the power cable is not trapped 

behind the main unit. 

Adjust the length of the power cable in the switch 

box so that the power cable does not become 

trapped. 

3.Gently press the appliance onto the wall, 

and fix it in place using 2 mounting screws.

Cautions

 

 If you are using commercially 

available φ 4 screws, use a washer 
(external diameter φ 10 or less) to 
prevent looseness. 

Installation panel 

Panel hooks 

Power cable

Mounting screws 
(Included)

Longer than 150mm

Plug positioning 

Mark the wall in 2 places

Move the power 
cable to the 
left side of the 
terminal cover. 

Terminal 
block 

Terminal cover 
mounting screw 

Rubber 

bushing 

Terminal cover 

Ferrite core
(Included)

Terminal cover

Power cable