Справочник Пользователя для Kodak 9090DC

A-61662   October 2011

1-7

Imprinter door — provides access to the optional imprinter for 
installation and maintenance. 

Straight pass-through door — allows you to use the optional 
straight pass-through adapter. When the door is open and the exit 
tray is attached, documents are fed through this exit. This is useful 
for scanning thick or stiff documents. Only open this door when you 
are using the straight pass-through feature, if the door is opened 
while scanning in rotary mode, a document jam will occur.

NOTE: When the straight pass-through door is open, the Back Door 

status light on the control panel will be lit.

SCSI connector — connects an optional SCSI cable (cable and 
SCSI card are not provided).

USB connector — connects the USB cable to the scanner and 
host PC.

Fan — for cooling the scanner. The fan is part of the scanner’s 
power supply. Make sure to properly vent the scanner for optimal 
performance.

Power connector — connects the power supply to the scanner.

Power switch — turns the scanner on (I) and off (O).

Foot — four rubber feet allow for clearance below the scanner.

Intake vent (on side) — used for drawing air in for cooling. Be sure 
to position the scanner in such a way that the intake vent is not 
blocked.

NOTE: Be sure to maintain an additional 4-5 inches (10-13 cm) of 

additional clearance at the front, back and sides of the scanner 
for proper ventilation.