Справочник Пользователя для Kodak 9090DC

A-61662   October 2011

2-3

The Kodak Ngenuity Scanner is equipped to accommodate a SCSI 
connection for communication between the scanner and host PC. The 
optional SCSI connection can be used in lieu of the standard USB 
connection. 

To use a SCSI connection, a SCSI card and cable is required. Kodak 
does not provide a SCSI card or cable with the Ngenuity Scanner; 
therefore, these items must be purchased separately. A SCSI 
connection kit is not available through Kodak; however, Kodak has 
certified that Adaptec’s 29160 LP or regular profile card is compatible 
with Ngenuity Scanners. The SCSI cable must be a D68-pin SCSI-3 
cable.

1. Without the scanner attached, turn on the host PC.

2. Load the Installation CD into the CD-ROM drive and install the 

software in the following order: Ngenuity VRS software first, then 
the Ngenuity Operator Utility (NOU). You do not need to reboot the 
host PC after installing each software application.

NOTE: For the latest drivers, go to www.Kodak.com/go/scanners.

3. Power down the host PC and remove the power cord.

4. Install the SCSI card (Adaptec 29160) in the host PC. See the 

5. Connect the host PC to the scanner.

6. Connect the power to the scanner and reconnect power to the host 

PC.

7. Turn the scanner on and wait for the initialization sequence to 

complete.

8. Turn on the host PC.

9. Follow the prompts within the New Hardware Found wizard.

10. Launch the Ngenuity Operator Utility (NOU) by double-clicking the 

NOU icon 

found on the desktop of the host PC.