Справочник Пользователя для Kodak 9090DC

A-61662   October 2011

6-11

Over time, the transport will become dirty and may feed documents 
erratically or skew the documents as they enter the scanner. To prevent 
erratic feeding, clean the transport every 50,000 pages or as needed. 

NOTE: It is recommended that you clean the imaging guides again after 

cleaning the transport with a transport cleaning sheet. 

1. Establish communication between the scanner and the Ngenuity 

Operator Utility.

2. Verify that one of the Custom Functions (F1 or F2) is set to Feed 

Test Batch.

3. Press F1 or F2 key depending on which key is assigned to “Feed 

Test Batch”. This will start the scanner transport. By default, the F1 
key is assigned the Feed Test Batch function.

4. Feed the transport cleaning sheet in landscape orientation into the 

scanner transport.

5. Observe the cleaning sheet, and run it through the transport again, 

changing its position slightly each time, until the tires leave no dark 
streaks.

6. Turn the transport cleaning sheet over and run it through the 

scanner transport two times.

7. Press and hold the Pause/Stop button (2-3 seconds) until the 

scanner stops running.

8. Press the Clear/Restart button.

9. When finished, discard the transport cleaning sheet. After running 

the cleaning sheet, inspect the imaging guides. It may be necessary 
to clean off any residue from the cleaning sheet that may be on the 
imaging guides.