Справочник Пользователя для Lucent Technologies Release 8.2
Configuration 3: R8si<—x.25 —> R8r Gateway
<—ethernet—> R8si
<—ethernet—> R8si
115
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000
CID: 77730
3
C-LAN Administration
Switch 2 Task — Assign Processor Channels
This task associates data links (hardware) with processor channels (software) on
Switch 2.
Switch 2.
Begin
Steps
> Open Processor Channel Assignment form — enter
ch com p
Note:
The Processor Channel number, the Interface Channel number, and the
Local and Remote Session numbers do not need to be the same number
but they should be made the same whenever possible to simplify network
“bookkeeping” and diagnostics.
Local and Remote Session numbers do not need to be the same number
but they should be made the same whenever possible to simplify network
“bookkeeping” and diagnostics.
> Enter values
change communications-interface processor-channels
Page 1 of X
Page 1 of X
PROCESSOR CHANNEL ASSIGNMENT
Proc Gtwy Interface Destination Session Mach
Chan Enable Appl. To Mode Link/Chan Node Port Local/Remote ID
1:
Chan Enable Appl. To Mode Link/Chan Node Port Local/Remote ID
1:
n
_______
_ __ _____ _________ 0____ ___ ___ __
2:
n
_______
_ __ _____ _________ 0____ ___ ___ __
:
21: y dcs____
_
2_ 21___
_________ 0____ 21_ 21_ 1_
23: y
dcs____
_ 2_ 23___
_________ 0_
_
23_ 23_ 3_
:
256: n
_______
_ __ _____ _________ 0____ ___ ___ __
Field
Conditions/Comments
Processor Channel 21
: (X.25 connection to Switch 1)
Enable
Set to
y
.
Appl.
Set to
dcs
for DCS signaling.
Mode
Used for TCP/IP connections only.
Interface Link
This must match the link number assigned on the procr-intf
data module screen.
data module screen.
Interface Chan
The interface channel number must be in the range 1 – 64
for an X.25 link.
for an X.25 link.
Destination Node
Used for TCP/IP connections only.
Destination Port
Used for TCP/IP connections only.
1 of 2