Справочник Пользователя для Lucent Technologies Release 8.2
Configuration 5B: R8csi <—ppp—> R8r (2 C-LANs)
<—ethernet—> R8si
<—ethernet—> R8si
187
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000
CID: 77730
3
C-LAN Administration
Switch 1 Task — Assign IP Route: C-LAN(a) to node-3
This task specifies a route for packets handled by C-LAN(a) destined for node-3. This
route is needed because node-1a and node-3 are connected via ppp and there are
intermediate nodes between them.
route is needed because node-1a and node-3 are connected via ppp and there are
intermediate nodes between them.
Begin
Steps
> Enable the ppp link on the node-1a data module screen:
ch da 2013
, set Enable Link? to
y
.
> Open the IP Routing form — enter
a ip n
[The system assigns the route number 1.]
> Enter values
> Submit the screen
End
add ip-route next
Page 1 of 1
IP ROUTING
Route Number: 1
Destination Node: node-3____
Gateway: node-1b
C-LAN Board: 1c07
Metric: 1
Destination Node: node-3____
Gateway: node-1b
C-LAN Board: 1c07
Metric: 1
Field
Conditions/Comments
Destination Node:
The name of the node at the destination of this route.
Gateway:
Node name of the gateway by which the destination node is
reached for this route.
reached for this route.
C-LAN Board:
The location of the C-LAN circuit pack that provides the
interface for this route.
interface for this route.
Metric:
Enter
1
, which indicates a complex route involving two
C-LAN boards.
See
Appendix A for more
information on the use of the Metric field.