Справочник Пользователя для Lucent Technologies Release 8.2
Configuration 5B: R8csi <—ppp—> R8r (2 C-LANs)
<—ethernet—> R8si
<—ethernet—> R8si
3
C-LAN Administration
Administration for Network Connectivity
CID: 77730
555-233-504 — Issue 1 — April 2000
188
Switch 1 Task — Assign IP Route: C-LAN(b) to node-2
This task specifies a route for packets handled by C-LAN(b) destined for node-2. This
route is needed because node-1b and node-2 are connected via ppp and there are
intermediate nodes between them.
route is needed because node-1b and node-2 are connected via ppp and there are
intermediate nodes between them.
Begin
Steps
> Enable the ppp link on the node-1b data module screen:
ch da 2378
, set Enable Link? to
y
.
>
Open the IP Routing form — enter
a ip n
[The system assigns the route number 3.]
> Enter values
> Submit the screen
End
add ip-route next
Page 1 of 1
IP ROUTING
Route Number: 3
Destination Node: node-2____
Gateway: node-1a
Destination Node: node-2____
Gateway: node-1a
C-LAN Board: 1c08
Metric: 1
Metric: 1
Field
Conditions/Comments
Destination Node:
The name of the node at the destination of this route.
Gateway:
Node name of the gateway by which the destination node
is reached for this route.
is reached for this route.
C-LAN Board:
The location of the C-LAN circuit pack that provides the
interface for this route.
interface for this route.
Metric:
Enter
1
, which indicates a complex route involving two
C-LAN boards.
Appendix A for more
information on the use of the Metric field.