Справочник Пользователя для Q-Logic 59060-02 B
3 – Event Messages
Alarm Events
3-8
59060-02 B
S
(A1003.003B) (Incomplete merge request sequence received, unable to process request.)
Meaning:
A remote switch sent a merge request that was not understood.
Action:
Check the remote switch for configuration errors or equipment
malfunction.
malfunction.
(A1003.003C) (Incompatible Zoning mode, Isolating link)
Meaning:
The fabric contains switches with a mix of interoperability mode
settings.
settings.
Action:
Configure all switches in the fabric to have the same value for
interoperability mode.
interoperability mode.
(A1003.003E) (Security: Ports downed for INVALID_ATTACH require administrative action
to be brought online.)
Meaning:
Meaning:
When deactivating a security set, ports that were previously
downed due to security violations remain down.
downed due to security violations remain down.
Action:
Reset the ports or place the ports online.
(A1003.003F) (ISL group empty and links up. Set ports offline to activate.)
Meaning:
Attempt at activating fabric binding with an ISL group that has no
members is not allowed due because there are inter-switch links
(ISL) logged in to the switch.
members is not allowed due because there are inter-switch links
(ISL) logged in to the switch.
Action:
Configure all ISLs offline or add each ISL member with fabric
binding information to the ISL group before activating.
binding information to the ISL group before activating.
(A1003.0040) (Zone Member type member_type unsupported.)
Meaning:
An invalid zone member type was discovered in a zone. ACL hard
zone membership must be defined by domain_ID and port number.
zone membership must be defined by domain_ID and port number.
Action:
Correct the member type.
(A1003.0041) (Zoning objects which contain Fibre Channel (FC) Address Members not
being sent to remote switch on save, not supported in this mode)
Meaning:
Meaning:
An attempt was made to assign a zone member by FC address
while Interop mode was disabled. When Interop mode is disabled,
zone membership must be defined by world wide name or
domain_ID and port number.
while Interop mode was disabled. When Interop mode is disabled,
zone membership must be defined by world wide name or
domain_ID and port number.
Action:
Enable Interop mode or change the zone membership type.