Справочник Пользователя для Mitsubishi Electronics XL21
REV 2.4
99
4. Adjustment software, “Wallaby”
4.1. General
“Wallaby” is a software program that can adjust a display wall through RS-232 format
communication. Up to 64 cubes in a display wall can be controlled separately according to the
allocated ID numbers.
This software works with Microsoft
communication. Up to 64 cubes in a display wall can be controlled separately according to the
allocated ID numbers.
This software works with Microsoft
®
Windows
®
95, Windows 98, Windows Me, Windows NT
®
Version4.0, Windows 2000 and Windows XP. It is recommended to use Windows NT Version4.0,
Windows 2000 or later.
Windows 2000 or later.
4.2. Installation
4.2.1. Software
Installation
1. Insert the set-up disk or copy the set-up files into a control PC and double-click the
Setup.exe.
2. Follow its installation messages until finish.
4.2.2. Connecting
Connect the Wallaby-installed PC to the master cube with a commercially available RS-232 cross
cable. Make sure that each cube in the display wall is connected with supplied control cables.
(Refer to chapter1.3, on page 23.)
cable. Make sure that each cube in the display wall is connected with supplied control cables.
(Refer to chapter1.3, on page 23.)
4.2.3. Dipswitch
setting
Make sure that the dipswitches of the cubes are set correctly. (chapter 1.4.2, on page 28.)
4.2.4. Starting the application
Execute the “Wallaby” for suitable models in Windows
®
start menu.
4.3. Initial set-up
Main window
4.3.1. Model
selecting
Click “Model Select” in “System Config” menu to select suitable model
range to be controlled. When you execute the application from the
appropriate Windows
range to be controlled. When you execute the application from the
appropriate Windows
®
start menu, this operation is not necessary.