Справочник Пользователя для Netopia R2020

Launch your terminal emulation software and configure the communications software for the following values. 
These are the default communication parameters that the Netopia R2020 uses.

Use your keyboard to navigate the Netopia R2020’s configuration screens, enter and edit information, and 
make choices. The following table lists the keys to use to navigate through the console screens.

Parameter

Suggested Value

Terminal type

PC: ANSI, VT100
Mac: ANSI, VT-100, or VT-200

Data bits

8

Parity

None

Stop bits

1

Speed

Options are: 9600, 19200, 38400, or 57600 bits per second

Flow Control

None

Note: The router firmware contains an autobaud detection feature. If you are at any screen on the 
serial console, you can change your baud rate and press Return (HyperTerminal for the PC 
requires a disconnect). The new baud rate is displayed at the bottom of the screen.

To...

Use These Keys...

Move through selectable items in a screen or pop-up menu

Up, Down, Left, and 
Right Arrow

To set a change to a selected item or open a pop-up menu of 
options for a selected item like entering an upgrade key

Return or Enter

Change a toggle value (Yes/No, On/Off)

Tab

Restore an entr y or toggle value to its previous value

Esc

Move one item up

Up arrow or Control + k

Move one item down

Down arrow or Control + j

Display a dump of the device event log

Control + e

Display a dump of the WAN event log

Control + f

Refresh the screen

Control + L

Go to topmost selectable item

<

Go to bottom right selectable item

>