Справочник Пользователя для Netopia CLI 874

IPSec/IKE

cp { name | index } ipsec suite encryption { des | 3des | null } 
         authentication { esp | ah } { md5 | sha1 } [compression { none | lzs }]

This command allows you to specify the IPsec suite encr yption type and authentication method for an IPsec 
tunnel.

cp { name | index } ipsec ip
   [remote {[members {xxx.xxx.xxx.xxx/nn | xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx}] [tep x.x.x.x]}]
   [local tep x.x.x.x] [via x.x.x.x]

This command sets all the per tinent IP values for the IPSec tunnel. There are three sub-sections of this 
command, the remote, local, and via. The remote section, if it exists, may contain a members or a tep (“tunnel 
endpoint”) parameter, or both. The local section, if it exists, may contain only a tep parameter. The optional via 
section sets the next hop gateway.

cp { name | index } ipsec ip [modify net-index ] 
    remote members remote IPv4-addr1 [ /nn  | remote IPv4-addr2 ] 
    local members local IPv4-addr1  [ / nn | local IPv4-addr2 ]

Note:

This command is suppor ted beginning with firmware release 8.2.

 Connection Profile IPSec Configuration Commands

cp { name | index } ipsec suite encryption { des | 3des | null } 
         authentication { esp | ah } { md5 | sha1 } [compression { none | lzs }]

cp { name | index } ipsec ip
   [remote {[members {xxx.xxx.xxx.xxx/nn | xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx}] [tep x.x.x.x]}]
   [local tep x.x.x.x] [via x.x.x.x]

cp { name | index } ipsec ip [modify net-index ] 
    remote members remote IPv4-addr1 [ /nn  | remote IPv4-addr2 ] 
    local members local IPv4-addr1  [ / nn | local IPv4-addr2 ]

cp { name | index } ipsec spi  rx-esp-spi [ tx-esp-spi [ rx-ah-spi [ tx-ah-spi ]]]

cp { name | index } ipsec authentication key string

cp { name | index } ipsec encryption key 1234567890123456 [1234567890123456 
1234567890123456 ]