Справочник Пользователя для Netopia 4542

Map Lists, Ser ver Lists, and PAT addresses are described in detail in 

■

You can specify a Filter Set. See 

.

■

You can remove a Filter Set.

■

You can choose to configure Advanced IP Profile Options (see 

 in the 

following section).

Note: The SPI title field above changes to SPI (Security Parameters Index) -- Use Advanced IP Profile Options 
if any of the SPI values differ from each other.

■

You can specify an ESP Receive SPI. The value must be unique over the set of all ESP SPIs specified for 
the remote tunnel endpoint.

■

You can specify an ESP Transmit SPI. The value must be unique over the set of all ESP SPIs specified for 
the remote tunnel endpoint.

■

You can specify an AH Receive SPI if AH authentication has been requested. The value must be unique 
over the set of all AH SPIs specified for the router.

■

You can specify an AH Transmit SPI if AH authentication has been requested. The value must be unique 
over the set of all AH SPIs specified for the remote tunnel endpoint.

■

You can specify a Local Tunnel Endpoint Address. If not 0.0.0.0, this value must be one of the assigned 
inter face addresses, either WAN or LAN. This is used as the source address of all IPsec traffic.

■

You can specify a Next Hop Gateway. If you specify the Remote Tunnel Endpoint Address, and the address 
is in the same subnet as the Remote Members Network you specified in the IP Profile Parameters, the 
Next Hop Gateway option allows you to enter the address by which the gateway par tner is reached.

                             Advanced IP Profile Options

         ESP Receive SPI:                   123456789
         ESP Transmit SPI:                  123456789
         AH Receive SPI:                    123456789
         AH Transmit SPI:                   123456789

         Local Tunnel Endpoint Address:     0.0.0.0
         Next Hop Gateway:                  0.0.0.0

SPI = Security Parameters Index, valid range is 1 - 4294967295.