Справочник Пользователя для IBM 4986B LanProbe

Download New Firmware
Xmodem Download of Firmware

88 

Xmodem Download of Firmware 

You can download firmware from your PC to LanProbe via Xmodem by using the 
following procedure:

1. Access the HyperTerminal Windows 95 application or a similar 

communications program which supports Xmodem file transfer.

 2. Connect your PC to LanProbe’s RS-232 connector using a null modem 

cable. Refer to “Cables and Connectors” on page 95, for more information 
on cables.

 3. Configure the terminal emulator for 8 bits/character, 1 stop bit, no parity, no 

flow control, and a baud rate of 9600.

 4. Connect the power cord to LanProbe and to a power source (either 100-120/

VAC or 220-240/VAC). LanProbe does not have a power switch, but is 
turned on by connecting power.

 5. Start the configuration by quickly pressing the CONFIG button on the back 

of LanProbe one time only. After about 10 seconds, LanProbe displays its 
Main Menu on the terminal, as shown in Figure 6-23.

 

Main Menu - Revision 

1. Modify/View configuration values ->

2. Modify/View security values ->

3. Modify/View interface values ->

4. Display interface summary

5. TFTP Download new firmware ->

6. XMODEM Download new firmware ->

7. Warm start and Exit

8. Cold start and Exit