Справочник Пользователя для IBM 4986B LanProbe
Installation
Installing the Probe
33
Table Installation
Place the probe on a flat surface or table (refer to the requirements listed in
“Selecting a Location” on page 31).
“Selecting a Location” on page 31).
Rack or Cabinet Installation
The LanProbe Rack Mount Kit is optional. The Agilent J2886A Rack Mount Kit
provides a support shelf and hardware for mounting LanProbe in a rack or cabinet.
The rack mounting kit requires a 3 1/2” slot in your rack and you will need a
POZIDRIV
provides a support shelf and hardware for mounting LanProbe in a rack or cabinet.
The rack mounting kit requires a 3 1/2” slot in your rack and you will need a
POZIDRIV
#1 screwdriver. The LanProbe Rack Mount Kit includes the
following:
z
One Support Shelf
z
One TORX‚T10 wrench
z
Four Clip-on sheet metal nuts
z
Four 0.55” (14 mm) 10-32 POZIDRIV
‚ screws
z
Four 0.75” (19 mm) #M4 self-tapping POZIDRIV
‚ screws
z
One LanProbe slot Cover
z
Two 0.312” (7.93 mm) #M3 machine screws
z
Four Dual Lock Reclosable Fasteners‚ strips
Optional Accessories
z
Support Rail Kit (12679C)
z
Female-Male Power Cable, 30” (8120-1575)
Use the following procedure to install LanProbe in a rack or cabinet (refer to the
requirements as listed in “Selecting a Location” on page 31 for additional
information):
requirements as listed in “Selecting a Location” on page 31 for additional
information):
1. Place LanProbe on its top with the front facing you.
2. Remove the two screws that are in the lower right-hand corner and in the
upper left-hand corner (looking down on LanProbe).