Справочник Пользователя для IBM ECS-320A

S

ERIAL 

I

NTERFACE 

D

EVELOPERS 

G

UIDE

 
 

Note: Once the command has been sent the embedded application will set the status code to 
BEGIN_PROCESS.  The host can monitor this code until it is returned to HOST_READY which 
indicates the routine has completed compiling the defects. 

Description:  Command to restore the active NUC table to the factory defect state.  When complete, 
the coefficients of the NUC table will be erased, except for the locations where defects from the factory 
compiled list have been incorporated. 

Command Code: Enumeration for CMD_RESTORE_FACTORY_DEFECTS 

Argument Size: 0 

Argument: None  

Note: Once the command has been sent the embedded application will set the status code to 
BEGIN_PROCESS.  The host can monitor this code until it is returned to DEFECT_COMPLETED or 
HOST_READY which indicates the routine has completed the restore process. 

Description:  Enable or disable the range reticle.  

Command Code: Enumeration for CMD_ENABLE_RANGE_RETICLE 

Argument Size: UWord16 

Argument: 0 – disable range reticle, 1 – enable range reticle 

Note: The reticle will only enable if the lens type is set for 100mm. 

Description:  Erases the active NUC table.  

Command Code: Enumeration for CMD_INIT_NUC_TABLE 

Argument Size: 0 

Argument: None 

Note: The Current NUC table information will be lost. 

Description:  Initiates a camera recover command (calls routine to reset the NUC mode and reload 
various FPGA registers).  

Command Code: Enumeration for CMD_CAMERA_RECOVER 

Argument Size: 0 

Argument: None 

Note: Intended to be used only if corruption of digital port data has been detected. 

Description:  Initiates a camera command that outputs current value of a shadow register to the write 
only expansion register.  The shadow register is located in the global configuration data structure.  

Command Code: Enumeration for CMD_UPDATE_EXP_PORT 

Argument Size: 0 

19