Справочник Пользователя для National Instruments NI PXI-7811R

© National Instruments Corporation

–

LabVIEW FPGA Module 1.1 or later—required to develop 
custom FPGA VIs for the PXI-7811R device

–

NI-RIO 1.1 or later—included with the PXI-7811R

❑

PXI/CompactPCI chassis and real-time PXI controller

❑

One of the following host computers, depending upon your 
application, running Windows 2000/XP:

–

PC

–

Laptop computer

–

PXI/CompactPCI embedded controller

❑

At least one cable and device for connecting signals to the PXI-7811R

❑

CAT 5 Ethernet crossover cable if the real-time PXI system is not 
configured on a network. To connect the PXI system to a network port, 
use a standard CAT 5 10/100Base-T Ethernet cable.

The following instructions describe how to install the NI-RIO device 
drivers and LabVIEW.

Use the following sequence when installing LabVIEW, the LabVIEW 
Real-Time Module for ETS, and the LabVIEW FPGA Module. For more 
detailed information about software requirements, refer to the LabVIEW 
FPGA Release Notes.

If you are using NI-RIO without LabVIEW, skip these steps and complete 
the steps in the 

 section.

You must install LabVIEW 7.0 or later and the LabVIEW modules you will be using 

with the NI 7811R before installing the NI-RIO device drivers. For LabVIEW installation 
instructions, refer to the LabVIEW Release Notes.

1.

Install LabVIEW for Windows from the LabVIEW CD.

2.

Install the LabVIEW Real-Time Module for ETS from the LabVIEW 
Real-Time CD.

3.

Install LabVIEW FPGA from the LabVIEW FPGA CD.

4.

Install the NI-RIO device drivers. Refer to the 

 section for driver installation instructions.