Справочник Пользователя для Radio Shack 43-3101

2

Slide 

 located inside the battery 

compartment to level 

,

 or 

.

Test the doorbell before permanently 
mounting it. With the indoor intercom plugged 
into a standard AC outlet, adjust 

 on 

the indoor intercom to its middle position. 
Press 

 on the doorbell intercom. The 

doorbell should sound.

1. Drill four 

3

/

16

 inch diameter holes into the 

mounting surface. Insert an anchor into 
each hole.

2. Align the supplied metal mounting 

bracket with the drilled holes and drive a 
screw (not supplied) through the bracket 
into each hole. Do not overtighten the 
screws.

3. Align the slot on the back of the doorbell 

with the hook on the mounting bracket. 
Carefully push the doorbell onto the hook 
and slide it down to secure it.

4. Once the doorbell is securely on the 

bracket, insert the pan-head machine 
screw (supplied) through the hole on the 
lower edge of the doorbell into the 
threaded holes in the bracket.  

Follow these steps to mount the indoor 
intercom on a wall. 

Note: You need two screws (not supplied) 
with heads that fit into the keyhole slots on the 
bottom of the intercom.

1. Mark the mounting screw locations 2

1

/

2

 

inches (64 mm) apart, one above the 
other.

2. Drill a starter hole at each mark.

3. Thread a screw into each hole until the 

screw’s head extends about 

1

/

8

 inch 

(3.5mm) from the wall.

4. Align the keyhole slots on the bottom of 

the intercom with the screw heads in the 
wall, then slide the intercom down to 
secure it and lift and extend the antenna.

Locate a standard AC outlet in the area where 
you want to hear the chime and use the 
intercom. Plug the indoor intercom’s power 
cord into the outlet. 

Caution: This product is equipped with a 
three-wire grounding-type plug ( a plug having 
a third grounding pin). This plug will only fit 
into a grounding-type power outlet. This is a 
safety feature. If you are unable to insert the 
plug into your AC outlet, contact your 
electrician to replace your outlet. Do not 
defeat the safety purpose of the grounding-
type plug.

Important:  Be sure you install the stations at 
least 10 feet away from each other. Placing 
the stations too close together produces 
feedback (a squeal or howl from the 
speakers). The stations can transmit up to 
300 feet, including between buildings, as long 
as they are connected to the same power line 
transformer.

Rotate 

 counterclockwise until it 

clicks. The POWER indicator lights. Then 
adjust 

 to the desired listening level. 

To turn off the indoor intercom, rotate 

 clockwise until it clicks. The POWER 

indicator turns off.