Справочник Пользователя для Mitel 5320e

5320e IP Phone – User Guide 

The Call Park feature allows you to place a call in a special hold state. You, or someone else, 
can then retrieve the call from any extension in the system. 

After parking the call, the system can automatically connect you to paging equipment so that 
you can announce the call to the requested party. 

1.  Do one of the following: 

 Press 

the

 Call Park feature key (must be programmed) 

 Press 

 (

TRANS/CONF), and then dial the appropriate feature access code. The 

display shows PARKED@, followed by the park destination and parking spot index (if 
applicable). Example: PARKED@ 1234 @ 02. 

2.  Dial the directory number on which to park the call (not required if the number is 

programmed to the 

Call Park feature key). 

3.  To inform a user that a parked call is waiting, do one of the following: 

  If automatic paging is enabled, announce the call and the park retrieve digits shown 

on the display. 

  If automatic paging is disabled, press the programmed 

Page key, or dial the 

appropriate feature access code, followed by the Paging zone number (if required). 
Then, announce the call and park retrieve digits shown on the display. 

 

Note: Paging over a loudspeaker is not permitted in handsfree mode; you must use the 
handset or headset. 

1.  Do one of the following: 

  Dial the appropriate feature access code. 

 Press 

the 

Call Park - Retrieve feature key (must be programmed). 

2.  Dial the directory number on which the call is parked (not required if the number is 

programmed to the 

Call Park feature key). 

3.  If there are multiple calls parked on the number, dial the two-digit index number to 

retrieve a specific call, or # to retrieve the longest parked call.