Справочник Пользователя для Toshiba DK40I

When enabled (LED 03 On), the microphone and Mic button LED is turned On at the start of an 
on-hook speakerphone call. For this feature to work, you must enable the MIC button lock 
operation (LED 02 On).

When receiving internal DN calls, the flexible Microphone Cutoff (

0LFURSKQ&XWRII

) button 

(Program 39) can be used to prevent room monitoring and Handsfree Answerback.

The 

0LF

 button turns electronic or digital telephone microphones On/Off:

With “Locked” (LED 02 On), the 

0LF

 button will be On or Off (depending on LED 03) when you 

begin the call and you can alternately push it On or Off. This does not apply to Handset OCA - 
which is 

0LF

 push-to-talk only.

With “Momentary” (LED 02 Off), the 

0LF

 is always On at the start of a speakerphone call/ You 

must continuously press 

0LF

 to disable the microphone when during a speakerphone call.

Enables (LED 01 On) or disables (LED 01 Off) speakerphone operation on any electronic or 
digital telephone. If disabled, a speakerphone:

♦

Can be used as a handsfree electronic or digital telephone.

♦

Enables talk back with the receiver on-hook when receiving an internal call.

♦

Will not allow you to talk on a call that you place or a call that you answer by pressing a 
ringing button with the handset on-hook.

1.

Use an LCD programming phone per Minimum Hardware 
Requirements on Page 1-14.
Make sure the programming button strip template is installed on the 
programming telephone. 

2.

✱✱✱✱

Enter programming mode. (Do not press [DN] button.)

3.

6SNU6SHDNHU+ROG

Access Program 30.

4.

6SNU6SHDNHU

Prepare the system for a station port selection.

5.

Enter the port number where the station being defined is connected. 
Use three digits, followed by a 

 button. A range of ports may be 

entered at once by using the 

✱ button. (See Note on system record 

sheet for port numbers.)