Справочник Пользователя для Nortel Networks 1000E
Installing and configuring a Voice Gateway Media Card
Page 329 of 488
Communication Server 1000E
Installation and Configuration
4
Exit from LD 14. Enter the command:
****
End of Procedure
Saving configuration changes
Perform a datadump to save configuration changes. Complete the steps in
Procedure 97: "Performing a datadump using Element Manager" on
Procedure 97: "Performing a datadump using Element Manager" on
MAXU
32
24
32 is the maximum number of voice Media Gateway channels on
the Media Card.
the Media Card.
For MG 1000T when XTRK = ITG2
24 is the maximum number of voice Media Gateway channels on
the ITG-P Line card.
the ITG-P Line card.
IPTN
YES
ITG Physical TN.
ZONE
0-255
MG 1000T Zone number to which the Voice Gateway Media Card
Physical TNs belong.
Physical TNs belong.
Verify that the zone exists in LD 117.
The ZONE prompt is not available when configuring VGW in an
MG 1000E. The VGWs are assigned the same zone as the
MG 1000E.
MG 1000E. The VGWs are assigned the same zone as the
MG 1000E.
Note: If the Zone of an MG 1000E is changed, all VGW in the
MG 1000E must be removed and reconfigured to assume the
new Zone of the MG 1000E.
MG 1000E must be removed and reconfigured to assume the
new Zone of the MG 1000E.
CUST
xx
The customer to which the IPTN resources are assigned.
Note: This means that for multi-customer CS 1000E systems,
each customer must have a dedicated IP Telephony node for
IP Phones.
each customer must have a dedicated IP Telephony node for
IP Phones.
Table 39
LD 14 – Configure physical TNs (Part 2 of 2)
LD 14 – Configure physical TNs (Part 2 of 2)
Prompt
Response
Description