Справочник Пользователя для Mitsubishi Electronics WD-62825

56

57

NetCommand

®

 Controlled Recordings

Setting up Recordings

Through NetCommand, you can automatically start 

and stop recordings and send signals from one 
playback device to a recording device.  Recordings 
can be made on recordable devices connected to the 

TV or to the internal TV Disc.  The TV Disc is an IEEE 
1394 hard disk drive, with 120 GB of memory and is 

available for CableCARD™, Ant 1, Ant 2, IEEE 1394 
or tuning devices (cable boxes or satellite receivers) 
connected to inputs 1, 2, 3 when a PIP or POP is not 
displayed.     

The TV can convert digital channels and IEEE 1394 

device signals to analog signals that can be recorded 
on NetCommand compatible analog VHS and S-VHS 
VCRs.  

You can schedule the recording to take place at a 

later time and program the recording duration for a 
minimum of 30 minutes and a maximum of 6 hours (in 
30 minute increments).  The default is 1 hour.  During 
the recording, the TV can be powered Off.  If the TV is 
powered On, it will be tuned to the source that is being 
recorded.  The TV should remain on this source to 

ensure the recording continue without interruption.

Recording Now

Can be used when viewing Antenna 1 or 2, an IEEE 

1394 device including TV Disc, or a non-recording 

traditional device. 

To initiate recording now:

1.  Press REC (record) on the TV remote.

2. Press DEVICE on the remote control to move to the 

Source Device section. 

3. Press ADJUST  ,  ,   or    to select the source 

device you will record from.  If a source is not 
displayed, it is not available as a recording source.

4.  Press ENTER to confirm selection and return to the 

“Record to” section.    

5. In the “Record to” section, review the destination 

device and duration.  Use ADJUST   or   to 
change, if necessary.

6. Press a second time and the recording will start.

Time-Delayed Recording

1.  Press REC (record) on the TV remote.

2. Press DEVICE on the remote control to move to the 

Source Device section. 

3. Press ADJUST  ,  ,   or   to select the source 

device you will record from.

4.  Press ENTER to confirm your source device 

selection and move to the Record to section.

5. Press ADJUST   or   to select the Record to 

device, duration time, start time (press ENTER after 
selecting hour, minutes and AM or PM to set the 
time) and day, using ADJUST   or   to change,.  
For devices that can select channels, select the 
channel.

6. Select Add and press ENTER to add the recording 

to the record list.  If your selection is successful, a 
confirmation message will be displayed.  If you pick 
overlapping times, day(s), or destination devices, 
you will see a message stating there is a conflict.

7.  To exit, press HOME on the TV remote after all 

recordings have been added.