Справочник Пользователя для Mitsubishi Electronics WD-62825

56

57

Record List

 Press GUIDE while viewing the Record To screen to see a 

list of all currently programmed recordings.  A maximum of 
32 recordings can be scheduled. 

Cancel Current Recordings

To cancel a recording in progress, press DEVICE to 

display the Device Selection menu and highlight the 
source of the recording.  Confirm that the icon for VCR 
(or recording device) is in the Connection Section next 
to the TV icon. Press the CANCEL button.  The icon for 
the VCR (or recording device) will disappear from the 
Connection Section to confirm the cancellation. 

To cancel a recording on the Record List, press ADJUST   

or   to select the recording, then press CANCEL.  To page 
through the list, press CH    or  .

Record List, Peer-to-Peer Connections

Peer-to-Peer Connections

A peer-to-peer connection allows the IEEE 1394 devices 

in your TV network to talk to each other without the 
further need of TV intervention once the peer-to-peer 
connection is established.  For example, the TV can 
setup a connection for an A/V Disc or DVCR that sends 
a recorded program to an IEEE 1394 monitor in another 
room.  NetCommand will establish the connection 
between the two devices.  Once the connection has been 
established, the TV can be turned off or used to watch 
another device.  Recording from digital channels to a 
DVCR is also a peer-to-peer connection.  In this case, the 

TV is one of the devices in the peer-to peer connection.

NOTE:  Multiple peer-to-peer connections can 
occur simultaneously, sometimes with the same 
source device.  

Setting up a Peer-to-Peer Connection

To establish a peer-to-peer connection:

1. Press CONNECT on the TV remote.

2.  Press DEVICE on the remote control to move to the 

Source Device section.

3. Press ADJUST    or   to select the source device 

you will record from.

4. Press ENTER  to confirm selection and return to the 

“Record to” section.    

5. In the “Record to” section, review the destination 

device (example: DVCR) and duration.  Change if 

necessary.

6.  Press CONNECT a second time to start recording.

Canceling a Peer-to-Peer Connection

After a peer-to-peer connection has been established, 

you can cancel it by highlighting the source device 
in the Device Selection menu.  Confirm that the on-
screen icon for the peer-to-peer connection is in the 
Connection Section next to the TV icon, then press  
CANCEL.  The connection will end and the destination 
icon will be removed.  If there is more than one peer-
to-peer connection for the same device, all of the 
connections will all be canceled.