Справочник Пользователя для 2WIRE F-116P

4-24

The remote fax machine has not 

answered after several redial 

attempts.

Try again. Make sure that the remote 

machine is operational.

The remote machine does not have 

the requested feature, such as a 

delayed transmission. It also occurs 

if the remote machine does not have 

enough memory space to complete 

the operation you are attempting.

Reconfirm the remote machine’s 
features.

The remote person did not answer or 

the line is already engaged.

Try again after a few minutes.

Power has turned off then on and the 

machine’s memory has not been 

saved.

You need to start again the job which 

you were trying to do before the power 

failure.

The Stop/Clear button is pressed 

during a copy or fax operation.

Try again.

The memory is full.

Delete unnecessary documents, 

retransmit after more memory 

becomes available or split the 

transmission into more than one 

operation.

When the machine failed in installing 
the new toner cartridge. 

Open the front door and take out the 

toner cartridge. 

Then re-install it. 

When the machine has encountered 
the LSU could not reach the READY 

state.

Enter the EDC mode.(Refe to EDC 

mode). And check the LSU  

Control Test. If the LSU is defective, 

replace it.

Small amount of toner is left in the 

cartridge. 

The estimated cartridge life of toner is 

close.

Prepare a new cartridge for 

replacement. You may temporarily 

increase the printing quality by 

redistributing the toner.

Small amount of toner is left in the 

cartridge.

Replace the toner cartridge.

When the machine detected the non-
feeding from BYPASS tray.

Clear the JAM.

You have tried to select a group 

location number where only a single 

location number can be used, such 

as when adding locations for a 

broadcasting operation.

Just use a one-touch or speed dial 

number or dial a number manually 

using the number keypad

The machine is waiting for a specified 
time interval to redial a previously 

busy station.

You can press OK to immediately 

redial, or Stop/Clear to cancel the 

redial operation.