Справочник Пользователя для RCA SPS36073

11

e) Partially  tighten  each  screw,  but  do  not  fully 

tighten the screws until all of them have been 
started (see Figure 6).

f)  Gently tighten each screw until they are firmly 

holding the unit in place. The top front edge of 
the unit should clear the overhang.

Mounting Suggestions
1)  If your cabinet has obstructions inside it which prevent you from using the template, cut out the corresponding 

area on the template, but do NOT cut out or through the screw holes.  

2)  If your cabinet has obstructions underneath it, which will interfere with the mounting of the unit, remove 

the obstruction before mounting the unit, or find another location to mount the unit.

3)  It is recommended that you wear safety glasses while drilling to prevent eye injuries.
4)  For wood cabinets, you may want to mark the hole locations with a nail, pressed gently but firmly into 

the wood so that a slight impression is made. This will also help keep the drill bit centered in the right 
location.

5)  Hold the drill firmly against the cabinet to keep the drill from “walking”.

c)  Insert  the  four  selected  screws  through  each 

hole from the inside of the cabinet going down 
(see Figure 5). 

Figure 5

Figure 6

d) Hold each screw head down and push the unit 

and spacers onto the screws, then hold the unit 
up until spacers are firmly against the bottom 
of  the  cabinet  (and  fully  nested  within  each 
other if you are using multiple spacers for each 
screw). 

Cabinet
Overhang

Equal to or
Longer than 
Cabinet
Overhang

Cabinet
Bottom

Spacers

Minimum

RCA SPS36073  English IB W012 OK.indd   12

8/21/2009   4:47:45 PM