Справочник Пользователя для Mitsubishi Electronics #NAME?
5
- 9
5.2 CC-Link Safety Relay Module
5.2.1 Start-up procedures
5.2.1 Start-up procedures
5
SETTINGS AND PROCEDURES BEFORE
OPERATION
5.2
CC-Link Safety Relay Module
5.2.1
Start-up procedures
Figure 5.7 shows start-up procedures for the CC-Link safety relay module.
Figure 5.7 Start-up procedures (1/2)
* 1: Refer to Section 5.3
Yes
No
Start
Install the modules to a control panel
or machine.
or machine.
Set the extension module station
number and extension communication
terminating resistor setting switch.
number and extension communication
terminating resistor setting switch.
*1
Connect the main module and an
extension module with a safety circuit
part extension cable.
extension module with a safety circuit
part extension cable.
*1
Mount a master module, local
module, and standby master module
on the base unit.
module, and standby master module
on the base unit.
Connect the main module with
CC-Link dedicated cable and connect
terminating resistor to both ends of
the module.
CC-Link dedicated cable and connect
terminating resistor to both ends of
the module.
Connect
an extension module?
Connect the monitor part (EA, EB, EG,
EP) with shielded cable.
EP) with shielded cable.
Connect a safety part terminating
connector to the last module.
connector to the last module.
Set start-up mode with start-up mode
setting switch.
setting switch.
(To next page)