Инструкции для Andrew Wireless Innovations Group RPT-MR701

Содержание

• table 1-1 List of international sales offices

  12
• figure 2-1 Block diagram of MR801B Power

  14
• figure 2-2 Top view of an RF module

  16
• figure 2-3 Top view of a mother board

  17
• figure 2-4 Top view of the control module

  18
• figure 2-5 Top view of the duplexers

  19
• figure 2-6 Top view of the active combiner module

  20
• figure 2-7 Mounting position of power supplies

  21
• figure 2-8 ON / OFF position of external switch

  22
• figure 2-9 Top view of the feed forward amplifier

  22
• figure 3-1 Position of rotary switches

  23
• figure 3-2 Position of failure LEDs

  24
• figure 3-3 Status hist report

  25
• table 3-4 List of all available alarms

  26
• figure 3-5 Example of a GET1 report

  27
• figure 3-6 Example of a STATUS report

  28
• figure 4-1 Clamps for external alarms

  30
• figure 4-2 Cable configuration and installation position

  32
• figure 4-3 Mounting position of batteries

  33
• figure 5-1 Screw terminal for mains cable

  37
• figure 5-2 Connector panel layout

  37
• figure 5-3 Position of external RF output

  39
• figure 6-1 System description

  40
• figure 6-2 Wall mounting brackets

  42
• figure 6-3 Clearance distance

  43
• figure 6-4 Grounding kit

  44
• figure 6-5 Screw terminal

  45
• table 7-1 LED indication

  46
• figure 7-2 Position of the DIP-Switch 1

  47
• figure 7-3 Position of the rotary switches

  48
• figure 7-4 Rotary switches and label

  49
• table 7-5 DIP-switch configuration

  49
• figure 7-6 DIP-switch 2 for local mode

  50
• table 7-7 List of AT commands

  52
• figure 9-1 Top view of the Repeater

  55
• figure 9-2 Fuse terminal

  56
• figure 9-3 Position of power supply fuse

  56
• figure 9-4 Position of RAM/RTC battery

  58
• figure 9-5 Position of dummy battery backup module

  59
• figure 9-6 Cable configuration of the duplexers

  60
• figure 9-7 Connector panel layout

  60
• figure 9-8 Top view of an RF module

  61
• figure 9-9 Position of hex coded rotary switches

  62
• table 9-10 Address of synthesizer

  62
• figure 9-11 Position of control module

  63
• figure 9-12 Power supply

  63
• figure 9-13 Position of special-nut M4

  64
• figure 9-14 Position of counter sunk screws on active combiner

  65
• figure 9-15 Position of the feed forward amplifier reset board

  66
• figure 9-16 Position of feed forward amplifiers (4-channel Repeater)

  67
• table 10-1 Spare parts list

  69
• figure 11-1 Installation drawing of the Repeater

  70
• figure 11-2 Top view of the Repeater (left side, one channel configuration)

  71
• figure 11-3 Top view of the Repeater (right side, one channel configuration)

  72
• figure 11-4 Cabling of one channel Repeater

  73
• figure 11-5 Block diagram of one channel Repeater

  74