Peerless Industries SUA746PU 用户手册

ISSUED: 10-24-11  SHEET #: 095-9364-1

Use a stud fi nder to locate the edges of the stud. Use of an edge-to-edge stud fi nder is highly recommended. 
Based on their edges, draw a vertical line down the stud’s center. Measure 4.8" (122 mm) left or right from stud's 
center to determine center of display mounting plate. Place wall arm (A) on wall as template, level, and mark the 
center of two mounting holes. Top mounting hole will be 6.66" above the center of display mounting plate as shown 
in fi gure 1.1.

Drill two 5/32" dia. holes to a minimum depth of 2.5". Secure wall arm (A) to wall with two wood screws (C) as 
shown in fi gure 1.2. For cable management option, install cable anchor (I) to bottom mounting hole with wood 
screw (C). NOTE: Be sure arrow is pointing up when mounting wall arm (A) to wall as shown in fi gure 1.1. Level, 
then tighten all fasteners.

Insert two fastener caps (H) into wall plate mounting holes.

= CENTER OF DISPLAY

ARROW

DISPLAY 

MOUNTING PLATE

6.66"

(169mm)

4.8"

(123mm)

•  Installer must verify that the supporting surface will safely support the combined load of the equipment and all 

attached hardware and components.

•  Tighten wood screws so that wall plate is fi rmly attached, but do not overtighten. Overtightening can damage the 

screws, greatly reducing their holding power.

•  Never tighten in excess of 80 in. • lb (9 N.M.).

•  Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud fi nder 

is highly recommended.

•  Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. 

Installers are responsible to provide hardware for other types of mounting situations (not evaluated by UL). 

1