Peerless Industries SUA746PU 用户手册

ISSUED: 10-24-11  SHEET #: 095-9364-1

•  Tighten screws so display brackets are fi rmly attached to display. Do not tighten with excessive force. 

Overtightening can cause stress damage to screws, greatly reducing their holding power and possibly causing 
screw heads to become detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.

•  If screws don't get three complete turns in the display inserts or if screws bottom out and bracket is still not tightly 

secured, damage may occur to display or product may fail.

To prevent scratching the display, set a cloth on a fl at, level surface that will support the weight of the display. Place 
display face side down. If display has obstructions on the back, remove them to allow the adapter brackets to be 
attached. Place adapter brackets (B) on back of display, align to holes, and center vertically on back of display as 
shown below. Attach the adapter brackets to the back of the display using the appropriate combination of screws, 
washers, and spacers, if required, as shown in steps 2-1 or 2-2.

NOTE: Top and bottom holes must always be used.

Verify that all holes are properly aligned, and then tighten screws using allen wrench (G).

2

CENTER BRACKETS 

VERTICALLY 

ON BACK OF 

DISPLAY

NOTE: "X" dimensions should be equal.

NOTE: For fl at back displays proceed to step 2-1. For bump-out or recessed back display skip to step 2-2.

NOTE: LATCHES 
INDICATED BOTTOM 
OF BRACKETS (B).