Peerless Industries SUA746PU 用户手册
7 of 29
ISSUED: 10-24-11 SHEET #: 095-9364-1
For Flat Back Display
For Bump-out or Recessed Back Display
2-1
Begin with the shortest length screw, hand thread through washer, adapter bracket and spacer, if required, into
display as shown below. If screw cannot make three full turns into the display and fi t snug into place, select a
longer length screw from the baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and
tighten screws.
display as shown below. If screw cannot make three full turns into the display and fi t snug into place, select a
longer length screw from the baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and
tighten screws.
NOTE: Spacers may not be used, depending upon the type of display.
NOTE: If display manufacturer's requirements state that more than 1.27" of ventilation is required, spacers may
be used to add an additional 0.75" of space between the wall and the display as shown below.
be used to add an additional 0.75" of space between the wall and the display as shown below.
Begin with the shortest length screw, hand thread through washer, adapter bracket and spacer, if required, into
display as shown below. If screw cannot make three full turns into the display and fi t snug into place, select a
longer length screw from the baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and
tighten screws.
display as shown below. If screw cannot make three full turns into the display and fi t snug into place, select a
longer length screw from the baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and
tighten screws.
WASHER
ADAPTER BRACKET (B)
DISPLAY
SCREW
DISPLAY
SCREW
ADAPTER BRACKET (B)
SPACER
WASHER
If you have any questions, please call Peerless customer care at 1-800-865-2112.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
DISPLAY
SCREW
ADAPTER BRACKET (B)
SPACER
WASHER
2-2