Multiquip J-SERIES 用户手册
J-SERIES WALK-BEHIND POWER TROWEL — OPERATION AND PARTS MANUAL — REV. #6 (09/30/10) — PAGE 19
J-SERIES TROWEL — ASSEMBLY AND INSTALLATION
Assembly and Installation
Before the trowel can be put into operation there are some
components that must be installed before the trowel can be used.
This section explains how to install those components.
components that must be installed before the trowel can be used.
This section explains how to install those components.
Handle Tube Installation (All Models)
1.
Install the
handle tube to the gearbox as shown in Figure 5.
The mounting hardware should be contained in the shipping
container.
container.
Figure 5. Handle Tube Installation
Quick Pitch™ Handle Installation (Quick Pitch Models Only)
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
The Quick Pitch™ handle is spring loaded,
personal injury or damage could result from
improper handling or installation. Be careful
personal injury or damage could result from
improper handling or installation. Be careful
when installing this component.
1.
Grasp the Quick Pitch™
T-handle from the operator's
position and squeeze the blade pitch adjustment trigger.
Move the
Move the
T-handle towards the engine as far as possible
(Figure 6). This will compress the spring inside the handle
tube. Allowing maximum exposure of the pitch cable.
tube. Allowing maximum exposure of the pitch cable.
2.
Lock the spring in the compressed position, by releasing
the blade pitch adjustment trigger.
the blade pitch adjustment trigger.
Figure 6. Blade Pitch T-Handle
NOTE
Considerable force may be required when
moving the Quick Pitch
moving the Quick Pitch
™
T-handle
forward or backward.