Roland AR-200 用户手册

 

Attach these as required, such as when you’re using the AR-200 without 
mounting it on a rack or the like.

Peel off the double-sided tape from the rubber feet and affix the rubber feet 
at the locations shown in the following figure.

 

fig.set-01

 

When you are mounting the unit on a rack or the like, give attention to the 
following points to ensure efficient cooling.
•  Install in a well-ventilated location.
• Avoid mounting in a sealed rack. Warm air within the rack cannot escape 

and is sucked into the unit again, making efficient cooling impossible.

• When you are using a stacked mounting arrangement, be especially sure 

to provide for adequate ventilation within the rack to keep discharged air 
from being sucked back into the unit. If the back surface of the rack cannot 
be kept open, then provide a ventilation port or ventilation fan at the 
upper area of the back surface of the rack, where warm air accumulates.

•  When you are using the unit in a portable case or rack, remove the covers 

from the front and back surfaces of the case, so that the front and back 
surfaces of the unit are not obstructed.

• If an error message informing you of a dangerous rise in temperature 

appears (p. 52), then heat-dissipating measures are needed. Refer to the 
cautions just described and check the installed state of the unit and the 
rack.

AR-200_e.book 10 ページ ２００３年７月１４日　月曜日　午後１時１１分