Roland AR-200 用户手册

 

• To prevent malfunction and/or damage to speakers or other devices, 

always turn down the volume, and turn off the power on all devices 
before making any connections.

• Once the connections have been completed, turn on power to your 

various devices in the order specified. By turning on devices in the 
wrong order, you risk causing malfunction and/or damage to speakers 
and other devices. 

   (When turning the power off, reverse this procedure.)

     Connected device 

 

→

 

 AR-200 

 

→

 

 Power amp, etc.

• This unit is equipped with a protection circuit. A brief interval (a few 

seconds) after power up is required before the unit will operate 
normally.

•  To avoid risk of electric shock, do not touch the connectors while the 

unit is in operation.

•  Never remove a card during recording of phrases. Furthermore, do not 

turn off the power or remove the AC adaptor cord during recording of 
phrases. Doing so may damage the card.

• To avoid the risk of malfunction and/or damage, insert only PC Card 

into the disk drive. Never insert any other type of disk. Avoid getting 
paper clips, coins, or any other foreign objects inside the drive.

• The pin assignment for the connectors is as shown below. Before making 

any connections, make sure that this pin assignment is compatible with 
that of all your other devices.

 

The AR-200 is not equipped with a power switch. Power is turned on when 
electricity is supplied to the power connector (for the supplied AC adaptor), 
or to the control input and DC input, or control I/O connectors’ DC IN (p. 8).

Supplied AC adaptor: ACI-100C (sold separately)

Control input and DC input/control I/O connector specifications

Voltage: 9 to 24 V DC

Current: 900 mA

Do not supply electrical 
power simultaneously to 
multiple connectors or 
terminals; doing so may 
result in damage to the 
unit.

GND(SLEEVE)

HOT(TIP)

COLD(RING)

GND(SLEEVE)

HOT(TIP)

With balanced output

With unbalanced output

AR-200_e.book 9 ページ ２００３年７月１４日　月曜日　午後１時１１分