Roland R-26 用户手册

Here’s how to listen to the playback 

through headphones or speakers you’ve 

connected.

•  No sound is played from the R-26’s 

preview monitor when headphones or 

speakers are connected to the PHONES 

jack.

•  Before switching the power on/off, 

always be sure to turn the volume 

down. Even with the volume turned 

down, you might hear some sound 

when switching the power on/off. 

However, this is normal and does not 

indicate a malfunction.

*  Once the connections have been 

completed , turn on power to your 

various devices in the order specified. By 

turning on devices in the wrong order, 

you risk causing malfunction and/or 

damage to speakers and other devices.

You’ll need to use speakers that have a 

built-in amplifier.
Use an audio cable to connect the R-26’s 

PHONES jack to the line input jacks of your 

speaker system.

Switch on the R-26’s power(p . 24) .

*  To prevent malfunction and/or damage 

to speakers or other devices, always 

turn down the volume, and turn off the 

power on all devices before making any 

connections.

*  This unit is equipped with a protection 

circuit. A brief interval (a few seconds) 

after power up is required before the 

unit will operate normally.

*  Howling could be produced depending 

on the location of microphones relative 

to speakers. This can be remedied by:

1.  Changing the orientation of the 

microphone(s).

2.  Relocating microphone(s) at a greater 

distance from speakers.

3.  Lowering volume levels.