Panasonic BL-WV10A 用户手册

16

Troubleshooting the BL-WV10A

[For assistance, please call: 1-800-272-7033]

153

Camera Quick Setup fails.

Are you following the procedures shown in 
"Connecting a camera"?

•

If registration fails, re-initialize the camera, 
turn the BL-WV10A off and then on again, and 
re-perform Quick Setup.

If you're using the BB-HGW700A, is an Ethernet 
cable connecting it to the BL-WV10A?
If you're using the BB-HGW700A, are its camera 
settings accurate?
In addition to the router, is there another 
Panasonic device serving as an access point?

•

Remove that access point from the network, 
and turn the BL-WV10A off and then on again.

[Setting wireless 
parameters...] appears.

This message appears when another BL-WV10A 
is connected. It indicates that the connected 
devices will have the same wireless settings 
configured for them.

It's taking a lot of time to 
register the cameras.

Network layouts may require a camera re-start, in 
which case registration can take up to 3 minutes.

The image from network 
cameras is not visible.

During Quick Setup, the BL-WV10A, after 
obtaining network data from the router, will seek 
out an IP address not currently in use for its own 
fixed IP. In addition, there are fixed IP addresses 
for cameras on which Quick Setup was 
performed. If the same IP address is chosen after 
Quick Setup, this will cause network problems.

•

Either change the IP settings for one of the 
duplicate IP devices, change the network 
settings for the BL-WV10A and the 
camera(s), or re-perform Basic Setup after 
resetting the default settings for the BL-
WV10A and re-initializing the camera(s).

A signal from a wireless 
router is being received, 
even though you're not 
using one.

This will happen when wireless information is 
received from connected devices besides the BB-
HGW700A which support Panasonic's Quick 
Setup protocol (including the BL-WV10A itself).