Panasonic BL-WV10A 用户手册

16

Troubleshooting the BL-WV10A

[For assistance, please call: 1-800-272-7033]

155

You cannot connect to a 
camera after registering it 
for the MAC address filter.

To register MAC address filtering for a wireless-
compatible camera, register both MAC addresses 
assigned to the camera (the MAC addresses for the 
camera’s wired interface and its wireless interface). 
Refer to the Operating Instructions included with your 
camera for information on confirming the camera’s 
MAC addresses.

After turning the power on, 
the indicator is either solid 
amber or flashing amber.

The Ethernet cable is not correctly connected.

•

Re-connect the Ethernet cable.

The router is not working properly.

•

Check the router.

You are attempting to connect a BL-C30A in wired 
mode but the wired/wireless switch is set to 
wireless, or you are attempting to work in a 
wireless mode and the wired/wireless switch is 
set to wired.

•

Set the switch to the appropriate setting.

The wireless settings are different for the router 
and the BL-WV10A. (for wireless cameras)

•

Re-perform Quick Setup.

The indicator continues to 
flash green.

The Quick Setup settings are incomplete.

•

Re-perform Quick Setup.

The indicator continues to 
flash red.

There is something wrong with a camera.

•

Contact your dealer.

The indicator is red.

Privacy Mode is turned on.

•

Either press the PRIVACY button on the front 
of the camera or turn off Privacy Mode (see 
page 111).

The indicator does not 
turn green when using the 
wireless LAN.

The signal is bad. (for wireless cameras)

•

Change the camera location, remove any 
potential obstructions and try the connection 
again.