Fujitsu C150-E049-02EN 用户手册

8 Press [Mode 1] and [Mode 2] at a time to

see Screen 4. The settings are stored to
EEPROM.

9 When you close the setup mode, press

[Stop]. Then the readable screen is
displayed.

ON/OFF “OFF” is default setting.

1

“1” is default setting.
This mode is used when the batch of paper which length are same
are scanned.
When the paper which tears and wrincled are scanned, Scanner
may mistake it also.

2

This mode is used when the batch of paper which length and
thickness are same are scanned.
However, when the thin papers are scanned, Scanner may mistake
to detect the Double-feed rarely.
In case of this, please test to scan the thin papers in advance.

<< SETUP MODE >>

IPC-2 SET

Screen 8

IPC-2 SET

No

Screen 9

IPC-2 SET

X

Screen 10

When you set the using of IPC-2 pre-set mode, you must set as follows.

10 At Screen 2, press [Mode 1] twice to go to

the IPC-2 SET screen. (Screen 8)

11 Press [Mode 2] to see Screen 9 or 10. If “No”

is displayed, IPC-2 pre-set mode is not used.
If pattern number (“1”-”5") is displayed,
IPC-2 pre-set mode is used. “No” or number
status flips each time you press [Mode 1].
(The default setting is “No”.)

12 If you press the [Mode 2] at Screen 9, you

return to Screen 8. The setting is stored to
EEPROM. If you press the [Mode 2] at
Screen 10, you go to Screen 12.