Sharp VL-NZ10S 用户手册

Attach the power source to the
camcorder, then slide the cassette
compartment door release and open the
cassette compartment door.

• After confirmation sound, the cassette

holder extends and opens automatically.

Insert a commercially available cassette
fully with the window facing outwards,
and with the erasure protect tab facing
upwards.

Press the W mark gently until the
cassette holder clicks into place.

• After confirmation sound, the cassette

holder retracts automatically.

Wait for the cassette holder to fully
retract. Close the compartment door by
pressing the centre until it clicks into
place.

Perform step 1 above, then take out the
cassette.

Cautions:
• Do not try to close the cassette compartment

door while the cassette holder is extending or
retracting.

• Be careful not to get your fingers caught in the

cassette holder.

• Do not apply force to the cassette holder except

when pressing the W mark to close it.

• Do not tilt the camcorder or hold it upside down

when you are inserting or removing a cassette. It
may damage the tape.

• Remove the cassette if you will not use the

camcorder for a long period of time.

• If you do not correctly close the cassette holder

in step 3, the cassette protection mechanism of
the camcorder might eject the cassette. If this
happens, repeat the insertion procedure.

• Do not attempt to pick up the camcorder by the

cassette compartment door.

Notes:
• If the battery power is too low, you may not be

able to eject the cassette. Replace the battery
pack with a fully charged one.

• See page 87 for more information on the video

cassette tapes intended for use with this
camcorder.

SA

VE

RE

C

Cassette compartment

door release

W mark

Erasure protect tab