Sharp VL-NZ10S 用户手册
Preparation
14
Installing the Lithium
Batteries
Batteries
Installing the Memory Battery
A lithium battery is used to store the memory of
the date and time settings.
the date and time settings.
1
Slide the cassette compartment door
release and open the cassette compart-
ment door.
release and open the cassette compart-
ment door.
Note:
• The cassette holder will extend and open
• The cassette holder will extend and open
when the camcorder is connected to a
power source. Be sure to close the cassette
holder before proceeding to the next step
(see page 12).
power source. Be sure to close the cassette
holder before proceeding to the next step
(see page 12).
2
Pull out the lithium battery holder using
a pointed object such as the tip of a
ballpoint pen.
a pointed object such as the tip of a
ballpoint pen.
3
Insert the lithium
battery into the
battery holder with the
battery into the
battery holder with the
H side of the battery
facing the m side of
the holder.
facing the m side of
the holder.
4
Push the battery holder back into
position. Press the W mark gently,
then close the cassette compartment
door by pressing the centre until it clicks
into place.
position. Press the W mark gently,
then close the cassette compartment
door by pressing the centre until it clicks
into place.
Removing the lithium battery
Perform steps 1 and 2 above,
then lift out the battery from the
battery holder.
then lift out the battery from the
battery holder.
CAUTION: Danger of explosion if battery is
incorrectly replaced. Replace only with the
same or equivalent type CR2025 recom-
mended by the equipment manufacturer.
incorrectly replaced. Replace only with the
same or equivalent type CR2025 recom-
mended by the equipment manufacturer.
X KEEP THIS BATTERY AWAY
FROM CHILDREN. IF SWALLOWED,
CONSULT A PHYSICIAN IMMEDIATELY FOR
EMERGENCY TREATMENT.
FROM CHILDREN. IF SWALLOWED,
CONSULT A PHYSICIAN IMMEDIATELY FOR
EMERGENCY TREATMENT.
Z BATTERY MAY EXPLODE IF
MIS-USED OR INSTALLED WITH POLARITY
REVERSED. DO NOT RECHARGE, DISAS-
SEMBLE OR DISPOSE OF IN FIRE.
MIS-USED OR INSTALLED WITH POLARITY
REVERSED. DO NOT RECHARGE, DISAS-
SEMBLE OR DISPOSE OF IN FIRE.
• Do not short-circuit, recharge, disassemble, or
heat the lithium battery.
• Should the lithium battery leak, wipe the battery
compartment clean, and then insert a new
battery.
battery.
• The lithium battery will last about one year under
normal usage.
Installing the Battery to Remote
Control (Only supplied with VL-
NZ10)
Control (Only supplied with VL-
NZ10)
A lithium battery is used to power the remote
control unit.
control unit.
1
Hold the remote control
facing down, and pull
out the battery holder
while pressing the tab
toward the centre.
facing down, and pull
out the battery holder
while pressing the tab
toward the centre.
2
Insert the lithium battery into the battery
holder with the H side of the battery
facing the m side of the holder.
holder with the H side of the battery
facing the m side of the holder.
3
Insert the battery holder back into
position.
position.
Notes on the Use of the Lithium battery
Lithium battery
holder
m mark
H side
m mark
Tab