Huffy M0073 用户手册

14

 WARNING: To prevent steering system damage and possible loss of control, 

the “MIN-IN” (minimum insertion) mark (A) on the stem must be below the top of the 
Locknut (B).

NOTE: Remove plastic Cap (E) from the 
end of the Stem (13).

1.  Insert the Stem (13) into the fork (fi g 

07).

2.  Point the Stem (13) towards the front of 

the bike.

3.  Tighten the Stem Bolt (C) just enough to 

hold it in position.

4.  If necessary, loosen the Handlebar 

Clamp Nut (D) and rotate Handlebar 
(12) into a comfortable riding position 
(fi g 08).

5.  Tighten Handlebar Clamp Nut  (D) just 

enough to hold it in position (fi g 08).

6.  Align the stem (13) with the front tire 

and tighten the stem bolt (C) securely 
(fi g 07).

 WARNING: Do not over tighten the 

stem bolt. Over tightening the stem bolt can 
damage the steering system and cause loss 
of control.

fig 07

C

13

A

A

B

E

B

•  If necessary, re-adjust Handlebar (12) (fi g 

08).

•  Tighten Clamp Nut (D).

NOTE: Do not over tighten.  Torque to 17 
ft-lbs.

 WARNING: If the handlebar clamp 

in not tight enough, the handlebar can slip 
in the stem. This can cause damage to the 
handlebar or stem, and can cause loss of 
control.

fig 08

D

12