Raritan Computer Home Security System 用户手册

Chapter 14: System Maintenance 
 

ƒ  SNMP Trap Destinations 

Default Firmware 

This option resets all device firmware files to factory defaults. 
This option does not change the CC-SG database.  

Upload Firmware to 
Database After Reset 

This option loads the firmware files for the current CC-SG version 
into the CC-SG database.  

Diagnostic Console 

This option restores Diagnostic Console settings back to factory 
defaults. 

IP-ACL Tables 

This option removes all entries from the IP-ACL table. 

IP-ACL settings are reset with a Full Database reset whether you 
select the IP ACL Tables option or not. 

 

1.  Before you reset, back up CC-SG and save the backup file to a 

remote location. See 

 (on page 194). 

2.  Choose System Maintenance > Reset. 

3.  Select the reset options. 

4.  Type your CC-SG password. 

5.  Broadcast message: Type the message that will display to users who 

will be logged off CC-SG. 

6.  Enter the number of minutes (from 0-720) that should elapse before 

CC-SG performs the reset operation. 

If specifying over 10 minutes, the broadcast message displays to 
users immediately, and then repeats at 10 and 5 minutes before the 
event occurs. 

7.  Click OK. A message appears to confirm the reset. 

Do NOT power off, power cycle, or interrupt CC-SG when reset is in 
progress. Doing this may result in the loss of CC-SG data. 

 

The restart command is used to restart the CC-SG software. Restarting 
CC-SG will log all active users out of CC-SG. 

Restarting will not cycle power to the CC-SG. To perform a full reboot, 
you must access Diagnostic Console or the power switch on the CC-SG 
unit. 

1.  Choose System Maintenance > Restart. 

2.  Type your password in the Password field.