Enviro EG 28 B 用户手册

 

 

WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION  

MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. 

 
A)  This appliance is equipped with a pilot, which must be lit by 

hand by following these instructions exactly. 

B)  BEFORE LIGHTING smell all around the appliance area 

for gas, and next to the floor because some gas is heavier 
than air and will settle on the floor. 

WHAT TO DO IF YOU SMELL GAS:   

•  Do not try to light any appliance. 
•  Do not touch any electrical switch; do not use any 

phone in your building. 

•  Immediately call your gas supplier from a neighbor’s 

phone. follow the gas supplier’s instructions. 

 

•  If you cannot reach your gas supplier, call the fire 

department. 

C)  Use only your hand to  push in or turn the gas control 

knob.  Never use tools.  If the knob will not push in or turn 
by hand, do not try to repair it .  Call a qualified service 
technician.  Force or attempted repair may result in a fire 
or explosion. 

D)  Do not use this appliance if any part has been under 

water.  Immediately call a qualified service technician to 
inspect the appliance and to replace any part of the 
control system and any gas control which has been under 
water 

 
1.  STOP!  Read the safety information above.  
2.  Turn off all electrical power to the appliance. 
 
3.  Turn the gas control knob clockwise 

to 

the “off’ position. 

 

4. Open 

door. 

 Wait five (5) minutes to clear out any gas.  

Close door.  If you smell gas including near the floor, 
STOP! Follow  “B” in the above safety information. 
If you don’t smell gas go to next step. 

5.  Find the pilot located to the right between the front  and 

rear burner. 

6.  Turn gas control knob counter-

clockwise to “PILOT”. 

7.  Push the gas control knob in fully and hold.  Immediately 

light the pilot by pushing the piezo spark igniter.  Keep 
knob depressed for about 30 seconds after pilot is lit.  
Release knob.  If pilot goes out, repeat steps 4 through 6.  

WARNING  The gas valve has a lockout device, which will not 

allow the pilot burner to be re-lit until the thermocouple, 
has cooled. 

If the knob does not pop up when released, stop and 

immediately call your service technician or gas supplier. 

 

thermocouple and that the burners light completely. 

 

If the pilot will not stay 
lit after several tries, 
turn the gas control 
knob to “OFF" and 
call you service 
technician or gas 
supplier. 
 
 
 
8.  Turn gas control knob counter-clockwise 

to   the “ON” position. 
Flip burner switch to “ON” then turn “HI / LO” knob to the 
desired setting. 

HI \ LO knob 

Control knob 

 
9.  Turn on all electrical power to the unit

 

Turn the gas control  knob clockwise to “OFF” DO 

NOT FORCE  

1.  Turn off all electrical power to the appliance if service is to be performed. 
2.  Flip burner switch to off. 
 
 
 
 
 
 
 
 
 

 

9